Flashing a new firmware version on the tracking devices FOX3 and BOLERO40 series via a terminal SW
How to flash a new firmware version on the tracking devices FOX3 and BOLERO40 series via a terminal SW?
Open a terminal SW like HyperTerminal , PComm Terminal Emulator or TeraTerm.
Connect the FOX3 to the terminal and set the baud rate of the terminal SW accordingly (default 115200 baud).
Turn on the FOX3 and immediately hit <enter> to enter the FBoot (Fig. 1)
To get more information on the commands for the FBoot, you can type Help<enter> to list all commands (Fig. 2).
Fig. 1: FBoot
Fig. 2: Help
Type fwrite then hit <enter>
Send the FW with the extension .txt as ASCII (example avl_3.0.0_rc20_20170322.txt) (Fig. 3)
Fig. 3: fwrite and transmit the FW as ASCII
Fig. 4: Transmission phase. In this terminal SW it does not show the progress-bar of the transmission.
When the serial transmission is ended, a new window opens telling that the transmission of the file was OK (Fig. 5)
Hit OK then type “Reset<enter>” to restart the device. The FOX3 will restart and load the new FW.
NOTE: The existing Configuration will be kept available.
Fig. 5: Transmission is completed