How can I set a Spider or Spider Duo to factory defaults?

• Use the serial interface with a terminal emulator program set to
• • 9600 or 115200
  • 8 bit characters
  • No parity
  • 1 Stop bit
  • No flow control
• Set your terminal emulator to 9600
• Use a paperclip or something similar to push the reset switch thru the pinhole on the bottom of the Spider:
  
  
• Press down and hold the esc-key then release the reset switch
• The Spider should show a => prompt
• Type the command 'defaults' at the => prompt
• If you have an older Spider and can't get the => prompt after several tries at 9600, change the serial speed of your emulator to 115200 and try again
• • Earlier firmware sets the console port to 115200 by default.

For more details, see answer 1584:
Setting a Spider to factory defaults from the serial console port

Also, see the Spider/Spider Duo Quick Start Guide and User Guide, available here:
http://www.lantronix.com/pdf/Spider_QS.pdf
http://www.lantronix.com/pdf/SpiderDuo_QS.pdf
http://www.lantronix.com/pdf/Spiders_UG.pdf

[Originally Published On: 11/07/2011 04:00 PM]