Connect modes for Cobos based devices

The text based Setup page on my device server requires a hexidecimal number for the Connect Mode. What hex values are valid for the Connect Mode? I see the User Guide shows which bits to set, with a few example hex values. Is there an easier way?


Connect Mode defines how the Cobos based Device Servers make a connection, and how they react to incoming connections over the network. The chart below with lists all valid connect modes for Cobos based devices.

Values not listed in this table should be avoided.

Valid Standard Connection Modes

Mode Accept Incoming Connection Response Startup Datagram Type Modem Mode
00 Never Nothing No Active
01 Never Nothing With Any Character
02 Never Nothing With Active DTR
03 Never Nothing With CR (0x0D) only
04 Never Nothing Manual Connection
05 Never Nothing Autostart
06 Never Nothing Modem Mode With Echo
0C Never Nothing Directed UDP Directed UDP
10 Never Character No Active
11 Never Character With Any Character
12 Never Character With Active DTR
13 Never Character With CR (0x0D) only
14 Never Character Manual Connection
15 Never Character Autostart
16 Never Character Modem Mode No Echo
1C Never Directed UDP Directed UDP
40 With DTR Nothing No Active
41 With DTR Nothing With Any Character
42 With DTR Nothing With Active DTR
43 With DTR Nothing With CR (0x0D) only
44 With DTR Nothing Manual Connection
45 With DTR Nothing Autostart
46 With DTR Nothing Modem Mode With Echo
4C With DTR Nothing Directed UDP Directed UDP
50 With DTR Character No Active
51 With DTR Character With Any Character
52 With DTR Character With Active DTR
53 With DTR Character With CR (0x0D) only
54 With DTR Character Manual Connection
55 With DTR Character Autostart
56 With DTR Character Modem Mode No Echo
5C With DTR Directed UDP Directed UDP
C0 Unconditional Nothing No Active
C1 Unconditional Nothing With Any Character
C2 Unconditional Nothing With Active DTR
C3 Unconditional Nothing With CR (0x0D) only
C4 Unconditional Nothing Manual Connection
C5 Unconditional Nothing Autostart
C6 Unconditional Nothing Modem Mode With Echo
CC Unconditional Nothing Directed UDP Directed UDP
D0 Unconditional Character No Active
D1 Unconditional Character With Any Character
D2 Unconditional Character With Active DTR
D3 Unconditional Character With CR (0x0D) only
D4 Unconditional Character Manual Connection
D5 Unconditional Character Autostart
D6 Unconditional Character Modem Mode No Echo
DC Unconditional Character Directed UDP Directed UDP


Values not listed above are not supported and should not be used.



[Originally Published On: 08/08/2006 05:12 PM]