...
The current released version of firmware for the PremierWave XC HSPA+ is v8.1.0.1R3.
IMPORTANT UPGRADE NOTE - If you are currently running firmware version lower than 7.9, you MUST upgrade to version 7.9 using Device Installer Firmware Recovery. This procedure MUST be performed using Device Installer version 4.4.0.2 or higher. Read the Important Upgrade Note below before proceeding.
The latest version of Device Installer can be downloaded here.
Upgrading the firmware using serial recovery will result in a factory restored configuration, so you will need to re-configure the unit or load a saved configuration.
...
LOAD THE FILE BELOW ONLY IF YOUR UNIT IS RUNNING 7.9.0.0R11. LOAD THIS FILE BEFORE LOADING 8.1.0.1R3.
DO NOT LOAD THIS FILE PRIOR TO LOADING 8.1.0.1R3 IF YOUR UNIT IS ALREADY RUNNING 8.0.0.0R16.
...
| File | Comment |
| Firmware | |
| Interim Upgrade Note | Right-click and choose "Save Target As..." |
| SHA Checksum | Right-click and choose "Save Target As..." |
| Interim Upgrader Release notes | Right-click and choose "Save Target As..." |
...
LOAD THE FILE BELOW ONLY AFTER YOU HAVE LOADED THE ABOVE 8.0.0.0B1 INTERIM UPGRADER OR IF YOUR UNIT IS ALREADY RUNNING 8.0.0.0R16.
...
Version 8.1.0.1R3 Base Firmware
...
If you have a PremierWave XC HSPA+ running the Base Version of firmware you can use the procedure in the Add-on Upgrade Note below to add Python. The notice refers to 8.0.0.0R16, but applies to 8.1.0.1R3, as well.
...